Manual Installation With Arp/Ping - Axis 210 User Manual

5. A message confirming that the IP address has been set will be displayed. Click OK.
6. Click View Home Page to access the camera's web pages.
7. See page 15 for instructions on how to set the password.
Note:
After installation, the One-click installation method can be used to obtain a DNS name for the AXIS
210/211.

Manual Installation with ARP/Ping

1. Acquire an unused IP address for the AXIS 210/211. This IP address must be on the
same subnet as your computer.
2. Locate the serial number (S/N) on the camera's underside label.
3. From a computer on your network, open a Command Prompt (in Windows: from the
Start menu, select Run... and type cmd in the field. Click OK).
4. As appropriate for your operating system, enter the following commands:
Windows syntax:
arp -s <IP Address> <Serial Number>
ping -l 408 -t <IP Address>
UNIX/Linux/Mac syntax:
arp -s <IP Address> <Serial Number> temp
ping -s 408 <IP Address>
5. Check that the network cable is connected. Start/restart the camera by disconnecting
and reconnecting the power cable, or the network cable if using PoE (AXIS 211 only).
6. Close the Command prompt when you see 'Reply from 192.168.0.125: ...'
7. The IP address has been set when the Power indicator is permanently lit and the
Network indicator flashes intermittently.
8. Start your browser, enter the IP address of the camera in the Location/Address field and
press Enter on your keyboard. See below for instructions on how to set the password.
Note:
After installation, the One-click installation method can be used to obtain a DNS name for the AXIS
210/211.
AXIS 210/211 - Manual Installation with ARP/Ping
Windows example:
arp -s 192.168.0.125 00-40-8c-18-10-00
ping -l 408 -t 192.168.0.125
UNIX/Linux/Mac example:
arp -s 192.168.0.125 00:40:8c:18:10:00 temp
ping -s 408 192.168.0.125
13