Warming Drawer Element - GE Profile PHB925SB1SS Technical Service Manual

Warming Drawer Element

• The warming drawer element is rated at 400
watts, has an approximate resistance value of
36 Ω, and draws approximately 3.3 amps.
• The element is located on the fl oor of the
warming drawer compartment. The element
terminals are located behind the element
terminal cover.
To remove the warming drawer element:
1. Disconnect power to the range.
2. Remove the range from the installation.
3. Remove the three 1/4-in. hex-head screws and
the element terminal cover from the back of the
range.
Cover
4. Disconnect the 2 element wires.
Disconnect
5. Remove the two 1/4-in. hex-head screws that
attach the element to the back wall.
6. Using a fl at blade screwdriver, lift the tabs on
each of the 2 clips and remove the element.
Disconnect
Clip
– 46 –
Warming Drawer Temperature Characteristics
Warming drawer temperatures are controlled by
duty cycling algorithms.
Low Temperature = 165° +/- 25°F.
Standard Temperature = 175° +/- 25°F.
High Temperature = 180° +/- 25°F.
Hi Warmer On Time
Warmer Off Time
100% First Rise On Time
Std Warmer On Time
Warmer Off Time
100% First Rise On Time
Lo Warmer On Time
Warmer Off Time
100% First Rise On Time
90 seconds
119
seconds
900
seconds
78 seconds
131
seconds
850
seconds
66 seconds
142
seconds
800
seconds