Side Panel Removal - GE Profile PHB925SB1SS Technical Service Manual

Side Panel Removal

The procedures to remove both the left and right
side panels are identical.
1. Disconnect power to the range.
2. Remove the oven door and warming drawer.
(See
Oven DoorAssembly, Warming Drawer
)
Assembly.
3. Remove the range from its installation.
4. Raise and support the cooktop or remove the
cooktop. (See
Cooktop Assembly
5. Remove the 1/4-in. hex-head hidden screw
located in the recess near the front leveling leg.
Recess
6. Remove the three 1/4-in. hex-head screws from
the rear of the side panel.
7. Remove the T-15 Torx screw and the 1/4-in hex-
8. Remove the Phillips-head screw and maintop
.)
Note: The front of the panel is held to the range
frame by 2 plastic grommets that engage 2 keyhole
slots placed along the inside front fl ange of the
panel.
9. Grasp the front and rear portion of the side
– 34 –
head screw from the top of the side panal.
strike from the top of the side panel.
Maintop Strike
panel. Lift the side panel up and pull towards
you, then disengage the two plastic grommets.
A
Grommet
Engaged (A)
B
Grommet
Disengaged (B)
Plastic Grommet
Plastic Grommet