Bake Element - GE Profile PHB925SB1SS Technical Service Manual

Bake Element

• The element is rated at 2850 watts, has an
approximate resistance value of 20 Ω, and
draws approximately 12 amps.
• The bake element is located under the oven
fl oor. The bake element terminals are located
behind the left side access panel.
To remove the bake element:
1. Disconnect power to the range.
2. Remove the range from the installation, then
remove the left side panel. (See
.)
Removal
3. Remove the two 1/4-in. hex-head screws from
the left side of the induction module air inlet
vent.
Module Inlet Vent
4. Carefully peel the refl ective tape from the
5. Grasp the bottom of the air tunnel. Push it up
6. Remove the 1/4-in. hex-head screw and the
7. Remove the 1/4-in. hex-head screw that
Side Panel
Refl ective Tape
8. Push up and disengage the lower heat shield
Right Side Retainer
– 40 –
induction module air inlet vent.
approximately 3/4 inch, swing out the bottom
of the air tunnel, then pull it down from the
induction module air inlet vent.
upper heat shield.
attaches the lower heat shield to the range
frame.
Module Inlet Vent
Air Tunnel
from the hooked end of the right side wire
insulation retainer.
Upper
Heat
shield
Lower
Heat
shield
Lower
Heat
shield
(Continued next page)