Oven Components; Oven Temperature Sensor; Relay Power Supply Module (Rpsm) - GE Profile PHB925SB1SS Technical Service Manual

Relay Power Supply Module (RPSM)

To remove the RPSM:
1. Remove the rear cover. (See
Note: In the following step, do not remove the
orange relay jumper wires.
2. Disconnect the control board wire harnesses
and mark and disconnect wires that connect the
RPSM to the range.
3. Remove the 5 Phillips-head screws that attach
the RPSM to the relay board frame.
4. Transfer the relay jumper wires to the
replacement RPSM.
Jumper Wire
Jumper Wire

Oven Components

.)
Rear Cover Removal
– 36 –

Oven Temperature Sensor

The oven temperature sensor is connected to the
electronic range control
temperature sensor has an approximate resistance
of:
Ω at room temperature
• 1080
Ω at 350°F
• 1654
Ω at 865°F (Clean temperature)
• 2650
The oven temperature sensor has a resistance
change rate of 2 Ω per °F.
To remove the oven temperature sensor:
1. Disconnect power.
2. Remove rear cover. (See
3. Disconnect the sensor wire harness.
Disconnect
4. Remove oven racks.
5. Remove the 1/4-in. hex-head screw that
attaches the sensor to the broiler element
bracket.
6. Carefully pull the sensor and sensor wiring
harness from the oven liner.
at location J501. The oven
.)
Rear Cover Removal
(Continued next page)