Misfeed Detected Types And Detection Timings - Minolta EP1054 Service Manual

Hide thumbs Also See for EP1054:
Table of Contents

Advertisement

FrameMaker Ver.5.5(PC) EP1054/EP1085/EP2030 TROUBLESHOOTING
98.05.15
3-2.

Misfeed Detected Types and Detection Timings

• The following table lists the types of misfeed detection classified by the misfeed locations
and their corresponding detection timings.
Note
For the misfeed detection types and detection timings in the options, see the Service Man-
ual for the options.
<Paper Take-up Misfeed>
Type
Paper take-up failure
1st Drawer Paper Take-Up Sensor PC55 is not blocked (L) after
detection
the lapse of approx. 2.4 seconds after 1st Drawer Paper Take-
Up Solenoid SL2 has been energized during the third paper
take-up retry sequence.
2nd Drawer Paper Take-Up Sensor PC56 is not blocked (L) after
the lapse of approx. 2.4 seconds after 2nd Drawer Paper Take-
Up Solenoid SL3 has been energized during the third paper
take-up retry sequence.
Paper take-up trailing
PC55 is not unblocked (H) after the lapse of T seconds (which
edge detection
varies for paper sizes) after it has been blocked (L).
PC56 is not unblocked (H) after the lapse of T seconds (which
varies for paper sizes) after it has been blocked (L).
Leading edge detection
PC51 is not blocked (L) after the lapse of approx. 1.7 seconds
by Transport Roller Sen-
after PC55 has been blocked (L).
sor PC51
PC51 is not blocked (L) after the lapse of approx. 2.5 seconds
after PC56 has been blocked (L).
<Multi-Bypass Misfeed>
Type
Paper take-up failure
PC51 is not blocked (L) after the lapse of approx. 2.7 seconds
detection
after Manual Feed Paper Take-Up Clutch CL51 has been ener-
gized during the third paper take-up retry sequence.
Leading edge detection
PC54 is not blocked (L) after the lapse of approx. 2.5 seconds
by Paper Leading Edge
after Paper Transport Clutch CL2 has been energized.
Detecting Sensor PC54
<Transport/Separator Misfeed>
Type
Trailing edge detection
PC51 is not unblocked (H) after the lapse of T seconds (which
by Transport Roller Sen-
varies for paper sizes) after the TRON signal has been input.
sor PC51
Leading edge detection
PC54 is not blocked (L) after the lapse of approx. 1.5 seconds
by Paper Leading Edge
after PC51 has been blocked (L).
Detecting Sensor PC54
Trailing edge detection
PC54 is not unblocked (H) after the lapse of approx. 1.6 sec-
by PC54
onds after PC51 has been unblocked (H).
Detection Timing
Detection Timing
Detection Timing
T-13

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ep1085Ep2030

Table of Contents