Registering A Unit; Additional Handsets - Panasonic KX-TG6721AL Operating Instructions Manual

Programming
3
Select the handsets to be restricted by
pressing 1 to 6.
R All handsets registered to the base unit
are displayed.
R " " is displayed next to the selected
handset numbers.
R To cancel a selected handset, press
the same dial key again. " "
disappears.
4
5
Select a memory location by pressing 1
to 6. a
6
Enter the phone number or area code to
be restricted (8 digits max.). a
M N
R To erase a restricted number, press
.
Changing the base unit PIN
(Personal Identification Number)
Important:
R If you change the PIN, please make note of
your new PIN. The unit will not reveal the
PIN to you. If you forget your PIN, contact
an authorised service centre.
1
#132
2
Enter the current 4-digit base unit PIN
(default: "0000").
3
Enter the new 4-digit base unit PIN. a
a M N

Registering a unit

Operating additional units

Additional handsets

Up to 6 handsets can be registered to the
base unit.
Important:
R The additional handset model
recommended for use with this unit is noted
on page 4. If another handset model is
30
TG672xAL(en)_0125_ver011.pdf
Registering a handset to the
base unit
The supplied handset and base unit are
pre-registered. If for some reason the handset
is not registered to the base unit (for example,
near the base unit), re-register the handset.
1
a
2
3
Note:
R While registering, "Base in
R When you purchase an additional handset,
Deregistering a handset
A handset can cancel its own registration to
the base unit, or other handsets registered to
the same base unit. This allows the handset to
end its wireless connection with the system.
1
30
used, certain operations (handset settings,
base unit settings, etc.) may not be
available.
is displayed even when the handset is
Handset:
#130
Base unit:
Press and hold M N for about 5 seconds,
until the registration tone sounds.
R If all registered handsets start ringing,
press M N again to stop, then repeat
this step.
R The next step must be completed
within 90 seconds.
Handset:
a Wait until "Base PIN" is
displayed. a Enter the base unit PIN
(default: "0000"). a
R If you forget your PIN, contact an
authorised service centre.
R When the handset has been registered
successfully, is displayed.
registering" is displayed on all
registered handsets.
refer to the additional handset's installation
manual for registration.
#131
R All handsets registered to the base unit
are displayed.
2012/01/25 9:16:18