Stabilization Menu - Furuno FCV-1200L Operator's Manual

3.11

STABILIZATION Menu

The stabilization feature offsets heaving (ship's vertical movement) to give you steady images in
rough seas. This feature requires connection of a satellite compass.
NOTICE: The stabilizer cannot be used in the following instances:
•
Picture from external source is being displayed
•
Two-split screen of LOW: ZOOM+HIGH: ZOOM
•
Three-split screen of EXT+LOW+HIGH
•
Four-split screen of LOW: ZOOM/NORMAL+ HIGH: ZOOM/NORMAL
•
TARGET ECHO is set for SURFACE
•
NMEA VERSION in the NAV DATA menu is set for SPECIAL.
•
Heaving data is not input from the satellite compass
STABILIZATION: Turn the stabilization mode on or off. Turn it on when in rough seas, to get
stable bottom echo presentation. The symbol
the stabilization mode is active.
SENSOR: Select the satellite compass interfaced with this equipment.
ANT-TD LONG., ANT-TD TRNSV., ANT-TD HEIGHT: These items are set during the installation.
It is recommended to maintain the settings set at installation.
3-18
DISP ALM TX/RX USER-1/2
STABILIZATION
STABLIZATION : OFF
SENSOR : SC50/110
<High Frequency>
ANT-TD LONG. : 0.0m (-100 - +100)
ANT-TD TRNSV. : 0.0m (-100 - +100)
ANT-TD HEIGHT : 0.0m (0 -100)
<Low Frequency>
ANT-TD LONG. : 0.0m (-100 - +100)
ANT-TD TRNSV. : 0.0m (-100 - +100)
ANT-TD HEIGHT : 0.0m (0 -100)
Turn on/off stabilization mode.
[+]: Go to setting [EXIT (knob)]: Exit
appears at the top of the screen when
SYSTEM