Factory Presets - Minelab GPX-4000 Quick Start Manual

30

Factory Presets

The GPX-4000 is provided with a Factory Preset
selection of menu settings, suitable for first-time
users.
Until you become more familiar with the
GPX-4000, the detector can simply be operated with
the Factory Presets and the front panel controls.
To restore all Factory Preset settings:
1 Turn the detector off.
Function Setting
Select
2 Press and hold On/ Off until the Reset Defaults
3 Turn Function Select to the right to select All
On/Off
4 Turn Setting left or right to restore all Factory
Hold for
FP
To restore Factory Preset settings for the
current search mode:
1 Turn the detector off.
2 Press and hold On/ Off until the Reset Defaults
3 Turn Function Select to the right to select the
Function Setting
Select
4 Turn Setting left or right to restore Factory
On/Off
Hold for
FP
menu appears (approx. 5-6 seconds).
Settings, as shown on the diagram.
Presets.
menu appears (approx. 5-6 seconds).
current mode. The current mode is dependent on
the mode switch on the front panel. Note: If the
displayed mode is not the one you wish to restore
you must change the mode on the front panel.
Preset settings for that mode.
FP
Main Menu:
Volume Limit
Audio Tone
Signal Peak
Track Speed
GB Type
Sensitive
Iron Reject
Battery Volts
Manual Tune
Mode Edit:
Audio
Gain
Motion
Response
Range: Factory Preset:
1 to 40 25
1 to 100 50
1 to 20 15
Slow Medium
Medium
Fast
General General
Specific
Extra Smooth
Smooth
Off (All Metal) Off (All Metal)
1 to 30
- -
0 to 255 -
General: Patch:
Quiet Normal Boost
Normal
Boost
Deep
1 to 15 8 7
Very Slow Slow Medium
Slow
Medium
Fast
Normal, Normal Normal
Inverted
31
Deep:
Deep
9
Very Slow
Inverted