Replacement Procedures; Replacing The Feed Module Or Feed Module Tires - Kodak i1840 User Manual

Replacement
procedures
Replacing the feed module
or feed module tires
A-61555 March 2007
Downloaded from www.Manualslib.com
This section provides procedures for replacing the following parts. Use
the list below as a guideline for frequency of replacement.
• Feed module tires and separation roller tires — tire life will vary
depending upon paper types, environment and cleanliness. Nominal
tire life is approximately 500,000 documents; results will vary.
Degradation of feeder performance, multiple feeds, stoppages, etc.
indicate a need to change tires. Change all the tires on the feed
module and separation roller at the same time.
• Feed module and separation roller — it is recommended that you
install a new feed module and separation roller approximately every
4th tire change. Install a new feed module and separation roller at the
same time.
• Pre-separation pad — it is recommended that you change the pre-
separation pad at least as often as you change the feed module/
separation roller tires.
• Imaging guides — replace when the imaging guides are heavily
scratched and defects show in the image.
1. Remove the output tray.
2. Lift up the printer access cover.
3. Open the pod.
manuals search engine
5-15