Kodak i1840 User Manual page 20

3-4
Downloaded from www.Manualslib.com
Feeder Capacity: The input elevator can hold up to 500 sheets of
2
75 g/m
Before you begin scanning documents, make certain the documents
can be fed through the scanner easily.
• A stack of documents to be fed into the scanner must be arranged so
the leading edges of all documents are aligned under the feed
module; this allows the feeder to introduce documents into the
scanner one at a time.
• Staples and paper clips on documents may damage the scanner and
documents. Remove all staples and paper clips before scanning.
• Documents with missing corners, perforated edges, hole punches in
the margins, irregular and curled edges, torn, damaged, or crushed
pages can be transported successfully through the scanner. These
documents may require manual feeding.
• When scanning mixed-sized documents, in addition to lead-edge
alignment, you may also want to left- or right-edge align the
documents. This would allow offset feeding, especially when using
the Enhanced Printer.
• If in doubt about whether a specific damaged document can be
transported through the scanner, place the document in a clear
protective sleeve with the lead edge of the document aligned with the
folded edge of the sleeve. Sleeves should be manually fed, one at a
time, folded edge first, while using the gap release button. Ultrasonic
multi-feed detection is not recommended when using plastic sleeves.
NOTE: When scanning documents in a clear protective sleeve, the
manuals search engine
(20 lb.) paper.
input elevator side guides must be adjusted to accommodate
the width of the sleeve.
A-61555 March 2007