Bose VIDEOWAVE II Setup Manual page 12

Tab 8, 16 Tab 7, 15
P S
HYSICAL ETUP
2. Using the same bolts, attach the two straps to the
back of the monitor as shown.
CAUTION: The included screws are for use only into
wood-studded wall constructions with one-inch (max.)
drywall. For all other types of wall construction, please
contact a professional installer. Use caution to avoid any
electrical or plumbing lines running through the studs.
3. Locate the two wall studs closest to the straps.
Each strap should be attached to the wall stud
closest to it.
DO NOT attach both straps to the same stud.
12
Tab 6, 14 Tab 5, 13 Tab 4, 12 Tab 3, 11
4. Hold the bracket on the end of each strap against
the wall above the tabletop. Hold the bracket a
minimum of 18 in. (46 cm) or maximum of 24 in.
(61 cm) above the tabletop. In the center of each
wall stud, mark the location of the two holes in the
bracket.
Tabletop
5. Using a 7/64 in. (3 mm) drill bit (not included), drill
four pilot holes.
6. Secure each bracket to the wall using two of the
provided screws.
Tab 2, 10 English