Before You Call For Service - GE JCS968 Owner's Manual

Before You Call For Service...

Troubleshooting Tips
Save time and money! Review the charts on the following
pages first and you may not need to call for service.
Problem
Surface units will not
maintain a rolling boil
or cooking is not
fast enough
Surface units do not
work or they do not
work properly
Scratches (may appear
as cracks) on cooktop
glass surface
Areas of discoloration
on the cooktop
Plastic melted to
the surface
Pitting (or indentation)
of the cooktop
Frequent cycling
off and on of
surface units
Oven light does
not work
Oven will not work
Possible Causes
Improper cookware
being used.
The self-clean cycle has
been set.
A fuse in your home may be
blown or the circuit breaker
tripped.
Cooktop controls
improperly set.
Incorrect cleaning
methods being used.
Cookware with rough bottoms • To avoid scratches, use the recommended cleaning
being used or coarse particles
(salt or sand) were between
the cookware and the surface
of the cooktop.
Cookware has been slid
across the cooktop surface.
Food spillovers not cleaned
before next use.
Hot surface on a model
with a light-colored cooktop.
Hot cooktop came into
contact with plastic placed
on the hot cooktop.
Hot sugar mixture spilled
on the cooktop.
Improper cookware
being used.
Light bulb is loose or defective. • Tighten or replace the bulb.
Switch operating
light is broken.
Plug on range is not completely • Make sure electrical plug is plugged into a live,
inserted in the electrical outlet. properly grounded outlet.
A fuse in your home may be
blown or the circuit
breaker tripped.
Oven controls improperly set. • See the Using the oven section.
What To Do
• Use pans which are flat and match the diameter of
the surface unit selected.
• During a self-clean cycle, the surface units will not
work. Press the RESET/OFF pad to stop the self-clean
cycle or wait until the self-clean cycle is finished to set
and use the surface units. See the About the radiant
surface units section.
• Replace the fuse or reset the circuit breaker.
• Check to see the correct control is set for the surface
unit you are using.
• Scratches are not removable. Tiny scratches will
become less visible in time as a result of cleaning.
procedures. Make sure bottoms of cookware are clean
before use, and use cookware with smooth bottoms.
• See the Cleaning the glass cooktop section.
• This is normal. The surface may appear discolored
when it is hot. This is temporary and will disappear
as the glass cools.
• See the Glass surface – potential for permanent damage
section in the Cleaning the glass cooktop section.
• Call a qualified technician for replacement.
• Use only flat cookware to minimize cycling.
• Call for service.
• Replace the fuse or reset the circuit breaker.
37