( Wps Settings); Cannot Connect. Multiple Access Points Are Enabled. Is Displayed; Connection Failed. Is Displayed => Pa; Problems During Software Installation - Canon PIXMA MP640 series Getting Started Manual

Problems during Software Installation
( WPS
Settings)
The Machine is Not Displayed (Detected)
Cannot connect. Multiple access points are enabled. is Displayed
A
l""'~l·'''~'*''t>' • .,.~,,,,,_ ~<.l'o;n (_"'""'''''..... '''''
""""""",~~w,_"""...,.."""o~t .....
t:-_~_
I,;;,';.",
1
:
Cannot connect.
Mu~iple
access points are
enabled.
The message appears when multiple access points are
detected.
Wait for a while, then configure the settings again.
.ACtjQA
I1tM prilltuto
bot <lH.d (o~!d ~OI
1M!
6ftff.tl!d. dood< IN "rtwo<I< St:I'ti~.
before diddftlJ
,W>Gafl!J_
AfUrl'OlltwtnQlltf,oJlrinU!t,ifflll;lytakeafa.... mi_ _ fDrttMprimefall_d"«tal,o'im-"l""-...dtkn
didjl,lpd;mo).
For a wireless connection, make sure that you follow Check 1,2,3,4,5 and 6 of
"Connection Checklist" on page 11, then click Update (A).
For a wired connection, make sure that you follow Check 1, 2, 3, 7 and 8 of "Connection
Checklist" on page 11, then click Update (A).
Is the machine connected to a network?
For details on how to check if the machine is connected to a network, refer to "Confirm Connection
Status" on page 32 in the printed manual: Getting Started.
If the machine is not connected to a network, perform setup again by following the
procedures in "Wireless Setup" on page 22 and onward or "Wired Setup" on page 29
and onward in the printed manual: Getting Started.
Connection failed.
See the manual.
The message appears when an error occurs.
Check the access point settings, then configure WPS
settings again.
• For details on how to check the settings of the access point,
refer to the manual supplied with the access point or contact its
manufacturer.
For the procedure to configure WPS settings of the machine, refer
to "Wireless Setup Using WPS (Wi-Fi Protected Setup)" on page
26 in the printed manual: Getting Started.
When using an access point that does not support WPS, configure settings manually. For the
procedure to configure settings of the machine manually, refer to "Wireless Setup" on page 22 in
the printed manual: Getting Started.
Connection failed. is Displayed
Is the IP filtering feature enabled on the network device (router, access point, etc.)?
For details on how to check settings of the network device, refer to the manual supplied with the
network device or contact its manufacturer.
Set the network
device
to accept the IP address of the machine.
• For details on how to change settings of the network device, refer to the manual supplied with the
network device or contact its manufacturer.
To check the IP address of the machine, press the HOME button, then using the Easy-Scroll
Wheel and OK button, select Settings> Device settings> LAN settings> Confirm LAN
settings> Wireless LAN setting list or Wired LAN setting list, then check IP address.
4