Optical Disk Drive - Toshiba Satellite P100 Series Maintenance Manual

Replacement Procedures
4.9

Optical disk drive

NOTE: Do not apply excessive force to the top of an optical disk drive.
Do not touch the shaded portion of the figure below, when the drive is removed
or installed.
Removing an optical disk drive
The following describes the procedure for removing an optical disk drive (See Figure 4-
11and 4-12).
1. Remove Keyboard and next remove the following screws securing an optical disk
drive.
•
2. Disconnect an optical disk drive toward the arrow direction from the connector
CN26 on the system board.
M2.5 x 6.0B FLAT BIND
4-26
M2.0×6.0B FLAT BIND screw
Figure 4-11 Removing an optical disk drive
x1

Optical disk drive

Satellite P100 Maintenance Manual (960-Q02)
Push Out