System Installation - GE UFC 211 Operation Manual

8.1.3 Orientation
The Horizontal Mounting Bracket can be
configured to suit installation, in which the
System Cap points to the left or the right. The
bottom of the System is cradled in the concave
feature of the Cast Iron Stand. The figure below
shows the configuration for a right-pointing
System. For left-pointing System configuration,
flip both Cast Iron Stands up side down.
8.2 Installation
8.2.1 Depending on the particular installation,
orient the cast iron stands in either a left
pointing or rightpointing System configuration.
8.2.2 Connect the two Cast Iron Cross Members
together using the three 1/4" x 1" bolts and lock
nuts.
8.2.3 Attach the two ends of the Cross Member
assembly to the Cast Iron Stands using the four
5/16" x 1 1/4" bolts and lock nuts.
8.2.4 (a) FLOOR MOUNTING
If the System is mounted on the floor, the floor
surface must be leveled. Place patio blocks
beneath the Bracket assembly and level the
blocks with sand or stone if necessary.
Drill into the concrete floor or block and anchor
the Bracket with the four supplied concrete
bolts. Three of the concrete bolts come with the
System and the forth bolt is supplied with in
Horizontal Mounting Kit. If required, use the
shims supplied with the System for leveling.
Note: If the System is being installed on a
heated floor, use a 2'x2' patio stone for a base.
Do not drill the floor.
8.2.4 (b) WALL MOUNTING
The Bracket assembly must be mounted
directly to the wall studs or the two pieces of
2x4 lumber installed earlier. The four 2½" wall-
mounting anchoring bolts are for wood studs
only. If the wall is made of concrete, use
appropriate concrete bolts for this installation.
- Mark the first hole location on the stud or
lumber. Ensure that all spacing requirements
are satisfied.
- Drill a hole suitable for the supplied 2½"
anchoring bolt.
- Leaving one end of the Bracket assembly on
the ground for support, lift the opposite end of
the Bracket up, align the top mounting hole on
the Bracket assembly with the pre-drilled hole
on the wall stud, and secure the Bracket
assembly with one 2½" anchoring bolt. Do not
tighten this bolt completely.
- Swing opposite end of the Bracket assembly
upward. Level the Bracket. Mark the locations
of the remaining three anchoring bolts with a
pen or pencil.
- Lower the unattached end of the Bracket
assembly back to the floor.
- Pre-drill the three holes for the remaining
three 2½" anchoring bolts at the marked
locations.
- Lift Bracket assembly up again, insert the
three 2½" anchoring bolts, and tighten all four
anchoring bolts.

9. System Installation

9.1 The System is shipped fully assembled,
except for the System Base. Attach the System
Base to the Backpulse Tank, using the supplied
3/8" bolts and washers.
8