Trane PTEC-070 Operation & Maintenance Manual page 8

8
General
Information
Unit Accessories
This unit is designed for through-
the-wall installation in new or
existing buildings. To complete the
installation of this PTAC, an
insulated wall sleeve and an outdoor
grille (either the stamped aluminum
grille or the architectural grille) are
required.
The chassis and the cabinet front are
shipped in one carton. Optional
accessories to complete a particular
installation are shown in Table 1.
Note: Consult sales literature for the
appropriate voltage and amperage
selections, if applicable. For
additional details and illustrations of
the accessories, refer to the catalog
or the particular installation manual.
Table 1
Wall Sleeve Kit
Heater Kit
Architectural Grille Kit
Hydronic Heat Kit
Stamped Grille Kit
Power Vent Kit
Deflector Grille Kit
Fuse Holder Kit
Power Switch Kit
Circuit Breaker Kit
Condensate Disposal Pump Kit
Water or Steam Valve Kit
Accessory
Main Duct Kit
Subbase Kit
Extension Duct Kit
Leveling Legs Kit
Wall Thermostat Kit
Hard Wire Kit
Drain Kit
Key Lock Kit
Filter Kit
Remote Escutcheon Kit
Remote Temperature Sensor Kit
PTEC-M-1A