Evaporator - GE Profile PGCS1RKZ Technical Service Manual

Evaporator Thermistor
The evaporator thermistor is clipped to the suction
tube line of the evaporator. (See
accessing instructions.)
Evaporator Thermistor
Note: When replacing the evaporator thermistor,
splice a new thermistor into the harness using
connectors and procedures approved for damp/wet
conditions.
Silicone Grease
for

Evaporator

– 41 –
Evaporator
The following components must be removed in the
appropriate order to access the evaporator:
1. Unplug the refrigerator.
2. Remove the upper and lower freezer drawers.
(See
Top Freezer Drawer
Note:
• For added accessibility to freezer components,
it may be necessary to remove the double
drawers mullion assembly. (See
.)
Mullion Assembly
• Each upper drawer side rail assembly is held
in place by four 1/4-in. hex-head screws and a
hook that locks into an opening in the side of the
freezer.
3. Extend both upper drawer rail assemblies to the
open position.
4. Remove the four 1/4-in. hex-head screws that
attach each upper rail assembly to the freezer
wall.
5. Pull the front of the rail assembly towards the
center of the freezer and unhook the assembly
from the side of the freezer.
, .)
Bottom Freezer Drawer
Double Drawer
(Continued next page)