GE Profile PGCS1RKZ Technical Service Manual page 25

8. Remove the hinge cover on top of the
refrigerator door by removing the Phillips-head
screw and pulling it up.
9. Disconnect the door wire harness.
10. Remove the 1/4-in. hex-head screw from the
harness retainer.
11. Remove the 1/4-in. hex-head screw that
attaches the ground wire to the hinge.
12. Remove the two 5/16-in. hex-head screws that
attach the top hinge to the cabinet.
Cover
Disconnect
– 25 –
13. If removing the left-side door, open the right-
side door.
14. Tilt the door away from the cabinet. Lift the
door off the center hinge pin and carefully guide
the water lines and wire harness through the
opening in the center hinge.
Note: Ensure that the plastic hinge pin thimble
remains on the hinge pin or inside door hinge pin
hole located in the bottom of the door.
15. Place the door on a protective surface with the
inside up.