Fresh Food And Freezer Lights - GE Profile PGCS1RKZ Technical Service Manual

Double Coil Water Tank
The double coil water tank is located in the bottom
of the fresh food compartment. (See
.) The icemaker and dispenser water
Locator Views
tank supply tubes, connected to the water valve,
enter the fresh food compartment near the right
side tank. Both tubes connect to exit tubing using
John Guest couplings. Exit tubing located inside the
liner connects to the disconnect collars located near
the left-door bottom hinge and cannot be replaced.
To remove the water tank:
1. Remove the fruit and vegetable crisper drawers
and the crisper drawer cover and frame
assembly.
2. Using a fl at blade screwdriver, push the top
black plastic lock clip (if utilized) off each
coupling.
3. Carefully push the collar in while pulling each
water line out from the coupling.
4. Remove the two 1/4-in. hex-head screws that
attach each water coil.
Collar
Clip
Note: In the following step, water may drain from
disconnected tubing. Use care to avoid water spills.
5. Disconnect icemaker and water tank tubing
from the water valve. (See
6. Carefully pull water tank and tubing from the
fresh food compartment.
Components
Clip
Collar
.)
Water Valve
– 38 –

Fresh Food and Freezer Lights

Fresh Food LED Lights
Note: Setting the controls to OFF does not remove
power to the LED light circuit.
The fresh food section utilizes 9 LED light assemblies
and the freezer utilizes 1 LED light assembly. All 9
fresh food LEDs are wired in parallel.
When a door or drawer is left open continuously
for 10 minutes, the main control will turn off the
lights. Once the door or drawer is closed and then
opened, the 10-minute count starts over.
Fresh Food LED Schematic
FF LED ASM
BLACK
(ALL 9 FF LED
PINK
ARE CONNECTED
RED
IN PARALLEL)
J14-4 = LED Ground
J2-8 = 13 VDC
J5-3 = LED Enable
13.6 V RED
BLACK
(Continued next page)