Epson Stylus Photo R320 Service Manual page 73

EPSON Stylus Photo R320
External View
Groove
Compression Spring, 5.1
Lock, Stacker
Shaft and Positioning Hole
Figure 2-54. Removing "CDR Guide Assy." (3)
DISASSEMBLY AND ASSEMBLY
Star Wheel/CDR Sensor
Hooks
8. Remove "Compression Spring, 5.1" and "Lock, Stacker" from "CDR Guide,
Upper".
9. Release the connector cable of "Star Wheel/CDR Sensor" from the groove of
"CDR Guide, Upper".
Reinstalling "Star Wheel/CDR Sensor"
Match the Shaft (x2) of "CDR Guide, Upper" and the
positioning hole of "Star Wheel/CDR Sensor".
Route the connector cable correctly of "Star Wheel/CDR
Sensor" referring to the figure.
Reinstalling "CDR Guide, Lower"
Screw in the order as shown in the figure.
Reinstalling "CDR Guide, Upper"
Make sure that the hooks (x2) of "Lock Stacker" are
properly secured by the tension of "Compression Spring,
5.1".
Make sure that "CDR Guide, Upper" is securely secured
with the hooks (x7) of "CDR Guide, Lower" and there is no
gap between "CDR Guide, Upper" and "CDR Guide,
Lower".
Reinstalling "CDR Guide Assy."
Install "CDR Guide Assy." in the order of left edge, right
edge and middle.
Match the slot (x6) of "CDR Guide Assy." and the ribs (x6)
of "Frame, Main".
Check if "Link, CDR Left (Right)" is correctly installed.
Check if the connector cable of "Star Wheel/CDR Sensor" is
not interrupting "Link, CDR Right".
Check if "Frame, EJ Assy." works with "CDR Guide Assy."
and moves smoothly.
Reinstalling "Support Plate, Frame, Main"
Screw in the order as shown in the figure.
Disassembly
Revision B
73