Epson Stylus Photo R320 Service Manual page 64

EPSON Stylus Photo R320
Reinstalling "Guide, IC"
Screw in the order as shown in the figure.
Reinstalling "CSIC Board"
Check if "CSIC Board" is secured correctly.
Reinstalling "PW Sensor Board"
Check if "PW Sensor FFC" is correctly connected.
Check if "PW Sensor Board" is correctly secured with
"Cap, PW Sensor".
Reinstalling "CR Encoder Sensor Board"
Check if "CR Encoder Sensor Board" is correctly secured.
Check if "CR Encoder Sensor Board" is correctly
connected.
Reinstalling "Holder, FFC ; B"
Screw in the order as shown in the figure.
Reinstalling "Holder, Scale, Right (Left)"
Check if "Slider, Holder, Scale" is set.
Holder, Scale, Right
Figure 2-39. Reinstalling "Slider, Holder, Scale"
DISASSEMBLY AND ASSEMBLY
Holder, Scale, Left
Slider, Holder, Scale
Reinstalling "Carriage Unit"
Check if "Timing Belt" is correctly set to the installing
groove of "Carriage Unit".
Check if "Grounding Plate, Head" is installed to the proper
position of "Carriage Unit".
Timing Belt
Figure 2-40. Installing Position of "Grounding Plate, Head"
Reinstalling "CR Scale"
Make sure that "Extension Spring, 3.289" is not twisted.
Make sure to pass "CR Scale" through the slit of "CR
Encoder Sensor".
Make sure to install "CR Scale" with the cut-part on the left
edge up.
Reinstalling "Guide, CR"
Screw in the order as shown in the figure.
Disassembly
Grounding Plate, Head
Groove
Cut-Part
Figure 2-41. Reinstalling "CR Scale"
Revision B
64