Removing The System Board Access Cover - IBM 1454 Setup Manual

Removing the system
board access cover
1
Locate the access cover on the back of the printer.
2
Remove the four access cover screws (two at top, two at bottom).
3
Remove the access cover.
4
Use the illustration to locate the connector for the card you want to install.
Firmware and
flash memory
card connectors
5
Use the following table to locate the instructions you need.
To install a...
Memory card
Firmware card
Hard disk
Option card
Install memory, firmware, or option cards
20
Option card
connector
Memory card
connector
Hard disk
connector
Go to page...
21
22
23
24