Test Functions; Level T1 – Brew Group; Level T2 – Heating Unit; Level T3 – Hydraulic Circuit - Gaggia PLATINUM VOGUE Technical & Service Manual

5.1

Test functions

Platinum Vision
2 3
In the first three seconds after the
appliance is switched on, you can
enter test mode by pressing the keys
in the sequence shown on the left.
1
4
Level T1 – brew group
At this level, brew group gearmotor and associated microswitches function is tested.
t.1 - Brewing unit
Next
bu_current (mA) = 3
bu_home = OFF
bu_work = ON
bu_present = ON
bu_dregdrawer = ON
bu_door = ON
bu go bu go bu go
home
work stop
Level T2 – heating unit
At this level, you can check heater function and the associated ntc sensor.
t.2 - Heating unit
Next
boiler_temp (C°) =79.8
Cup
Boiler
*
heater
Level T3 – hydraulic circuit
At this level, you can test pump, solenoid valve, drip tray/water tank level, milk island and water/steam valve status sensor
function.
t.3
Next
Hydraulic circuit
flow_meter (p/s) = 0
driptray_sens = OFF
waterlevel_sens = ON
knob_milk = OFF
knob_water&steam = ON
knob_closed = OFF
milk island present = OFF
caraffe present = OFF
valve
pump *
water
TALEA Section 05
REV00 - August 06
Ideas with Passion
- bu_current (mA) - indicates current absorbed by gearmotor.
- bu_home - indicates state of brew group home position microswitch.
- bu_work - indicates state of brew group work position microswitch.
- bu_present - indicates state of brew group presence microswitch.
- bu_dregdraver - indicates state of coffee grounds drawer presence microswitch.
- bu_door - indicates state of side door closed microswitch.
- By pressing "bu go home" once, the gearmotor moves the brew group to the home position.
- By pressing "bu go work" once, the gearmotor moves the brew group to the work position.
- By pressing "bu stop" once, the gearmotor stops the brew group.
- boiler_temp (C°) - indicates the temperature of the water heater.
- Pressing "cup heater" once will turn the cup warmer on.
- Pressing "boiler" once will turn the heater on.
- flow_meters (p/s) - indicates revolutions per second of the hall sensor in the turbine.
- driptray_sens - indicates the state of the capacitive sensor reading the water level in the
drip tray.
- waterlevel_sens - indicates the state of the capacitive sensor reading the water level in the
water tank.
- knob_milk - indicates the state of the water/steam/milk-island knob in the milk position.
- knob_water&steam - indicates the state of the water/steam/milk-island knob in the water/
steam position.
- knob_closed - i
ndicates the state of the water/steam/milk-island knob in the closed posi-
tion.
t.0
Next
Software version
CPU_V01.04.09
*
* *
On entering test mode, the screen
shown in the screenshot opens.
Press the next key to move on to
subsequent levels.
1/17