Table of Contents
Advertisement
LIGHTING INSTRUCTIONS
Using the gas control light the water heater as follows:
1.
Stop, read the
2.
Remove the access cover.
3.
Depress the gas knob slightly and
turn fully clockwise so the white dot
"" (off position) faces the front,
aligning with gas knob position
indicator.
4.
Wait five (5) minutes so any build
up of unburnt gas can escape. If
you then smell gas, stop and follow
"C" in the
"Safety Information"
page 40. If you do not smell gas,
proceed to step 5.
5.
Depress the gas knob slightly and
turn anticlockwise so the red star
" " (pilot position) faces the front,
aligning with gas knob position
indicator.
6.
Depress the gas knob fully (until the red star disappears below the
housing) and after twenty (20) seconds, whilst keeping the GAS KNOB
depressed, repeatedly press the igniter button (for up to forty
(40) seconds) until the pilot flame ignites. The igniter is a red button
located below and to the right of the gas control.
Warning: Keep your face clear of the combustion chamber opening
while pressing the igniter.
Note: It is not possible to depress the gas knob fully if the gas control has
activated its safety shut-off feature. In this case, wait five (5) minutes for
the gas control to reset (this allows for any unburnt gas to escape).
7.
Keep the gas knob depressed for a further twenty (20) seconds and then
release.
8.
Depress the gas knob slightly and turn it anticlockwise so the red line
"l" (ignition position) faces the front, aligning with gas knob position
indicator, and hold there for five (5) seconds.
9.
Release the gas knob (the gas knob will automatically turn to the red flame
" " (on) position), and listen for the burner noise.
"Safety Information"
LIGHTING THE WATER HEATER
on page 40.
on
41
gas control
Advertisement
Table of Contents
