First Use; Functions And Controls At-A-Glance; Charging The Battery - Apex Digital AP-7S118 Instruction Manual

Charging the Battery

The Tablet 7 has a built-in battery that may not be fully charged on first use. It is highly
recommended to fully charge the battery upon first use. Included in the Table 7 package is
an AC power adaptor to connect to AC power outlet as well as a USB cable to connect to a
powered PC. Both methods can be used to recharge the internal battery. But recharging via
AC power will take less time than recharging via USB. Typically, the tablet 7 will indicate that
it in operating a low power condition and that it needs recharging (occurs at about 10-15%
power). It takes approximately five hours to recharge the battery via AC power or longer via
USB. And it is normal for the tablet to feel warmer during recharging.
APEX Tablet 7 Functions and Controls At-a-Glance
1 Camera
2 Power/Lock
Key
3 Earphone Jack For use with a standard 3.5 mm stereo headphone jack.
4 Micro USB Port
5 Power Jack
(DC Input)
6 Volume + Key
7 Volume - Key
8 Memory Card
Slot
9 Reset Button
(At bottom of
aperture.)
10 Speaker
0.3 MP camera on front of tablet (facing the user.)
Powers ON/OFF the tablet when held for about 3 seconds. Locks and unlocks the tablet in
Stand-by Mode.
Connect to a computer via Micro USB cable to transfer data (i.e. music, video, photo, data
files.)
Connects to an AC adapter.
Increases audio volume in either speakers or earphones.
Decreases audio volume in either speakers or earphones.
Slot for a memory card.
Press to reset the tablet. The aperture requires a paper-clip or other small, narrow-tipped item
to insert and trigger the reset. (Be careful not to apply undue pressure to the button located
inside the aperture. Do not use a knife or other bladed tool, as this may damage the unit, and
potentially cause personal harm. Data can be lost after you reset.)
4

First Use