Troubleshooting Guide - DeWalt XR Li-ION DCN690-XE Instruction Manual

For more serious or persistent problems, contact your nearest authorised D
WARNING: To reduce the risk of serious personal injury, ALWAYS disconnect battery pack from tool before servicing.
SYMPTOM CAUSE
Motor does not run with Trigger lock in locked position
trigger depressed
Tool is stalled, locking the motor from rotating
Tool is in the sequential actuation mode
Tool internal electronics need to be reset
Motor stops running after 5 seconds
Terminals are dirty or damaged
Damaged internal electronics
Damaged trigger
Battery is hot
Tool is hot
Motor does not run with Trigger lock in locked position
contact trip depressed
Dry fire lock out engaged, blocking contact trip from traveling fully
Tool is stalled, locking the motor from rotating
Bent contact trip
Motor stops running after 5 seconds
Terminals are dirty or damaged
Damaged internal electronics
Damaged trigger
Battery is hot
Tool is hot

TROUBLESHOOTING GUIDE

MANY COMMON PROBLEMS CAN BE SOLVED EASILY BY UTILIZING THE CHART BELOW.
WALT repair agent, or contact your D
E
WALT office at the address indicated in this manual.
E
FIX
Unlock trigger lock.
Rotate the stall release lever on the tool and the mechanism will release. If driver blade does not
return, remove battery and manually push driver blade back to home position.
Depress contact trip first before firing or switch to bump mode (DCN690 only).
Remove battery, wait 3 seconds and reinsert.
Normal operation, release trigger and redepress.
See authorised D WALT repair agent.
E
See authorised D WALT repair agent.
E
See authorised D WALT repair agent.
E
Let the battery cool or replace it with a cool pack.
Let the tool cool down before continuing use.
Unlock trigger lock.
Load more nails into magazine.
Rotate the stall release lever on the tool and the mechanism will release. If driver blade does not
return, remove battery and manually push driver blade back to home position.
See authorised D WALT repair agent.
E
Normal operation, release contact trip and redepress.
See authorised D WALT repair agent.
E
See authorised D WALT repair agent.
E
See authorised D WALT repair agent.
E
Let the battery cool or replace it with a cool pack.
Let the tool cool down before continuing use.
20