DeWalt XR Li-ION DCN690-XE Instruction Manual page 17

/
+ or
or any other combination.
Stall Release (Fig. 12)
If the nailer is used in rigorous application where all
available energy in the motor is used to drive a
fastener, the tool may stall. The driver blade did not
complete the drive cycle and the jam/stall indicator
will flash. Rotate the stall release lever (E) on the
tool and the mechanism will release. NOTE: The
tool will disable itself and not reset until the battery
pack has been removed and reinserted. If the
driver blade does not automatically return to the
home position, proceed to Clearing a Jammed
Nail. If the unit continues to stall please review the
mode selection, material and fastener length to be
sure that it is not too rigorous an application.
Clearing a Jammed Nail (Fig. 2, 13)
ERROR
If a nail becomes jammed in the nosepiece,
Reset tool by removing and
keep the tool pointed away from you and
reinserting battery pack or
follow these instructions to clear:
cycling trigger lock off. If
1. Remove battery pack from tool and
error code persist, take tool
to an authorized D WALT
E
2. Slide the spring-loaded pusher latch
service center.
3. Using the hex tool (K) provided,
FIG. 12
4. Rotate the magazine (G) forward.
5. Remove jammed/bent nail, using
6. If the driver blade is in the down position, rotate the stall release lever on the top
E
7. Rotate the magazine back into position under the nose of the tool and tighten hex
8. Reinsert battery pack.
9. Reinsert nails into magazine (refer to Loading the Tool).
10. Release the pusher latch.
11. Disengage the trigger lock-off when ready to continute nailing.
NOTE: Should nails jam frequently or the driver blade continually fail to reset, have
tool serviced by an authorized D
15
engage trigger lock-off.
to the base of the magazine to lock it
into place and unload nail strip.
loosen the two hex bolts (O) at the
top of the magazine.
pliers if necessary.
of the nailer.
NOTE: If the driver blade will not reset after rotating the stall release lever,
manually resetting the blade with a long screw driver may be necessary.
bolts.
NOTE: The tool will disable itself and not reset until the battery pack has been
removed and reinserted.
WALT service center.
E
O
FIG. 13
G