Managing Stations; Tv Stations - Loewe Xelos 40 Media Operating Instructions Manual

Managing stations

TV stations

Various options for managing stations are available via the TV menu. For
example the description for TV stations. For radio stations the same applies,
except that the Radio menu is called in Radio mode (see also page 50).
➠ Station management is not possible if a programmed timer recording
is still pending.
➠ If at least one station is locked the access code must be entered before
Search/Update (see Parental lock on page 54).
Search/update stations – Search wizard
In the search/update with the search wizard, new stations are searched
for which have not yet been stored.
➠ You have to repeat the initial installation (see page 22)
and automatically search for new ones if you want to
delete all the existing stations and automatically search
for new ones.
MENU: Call TV menu.
Select Settings,
go to the menu line below.
Select Stations,
go to the menu line below.
Select Search wizard,
go to the menu line below.
In the upper info text the current search settings will now
be displayed:
SEARCH WIZARD
Your TV carries out the update of the station list (search for new stations; delete
stations no longer broadcast) with the following settings:
Location of TV set
Signal source
TV MENU
Settings
Station
Search wizard
Change search settings
If you want to change these search settings:
Select Change search settings,
OK wizard prompts search settings.
If you agree with these settings:
Select Start search/update,
OK start search.
Red button: Abort current search/update.
- 40
United Kingdom
DVB-C
Start search/update
OK
Explanations of some search settings:
Set location Select the country for country-specific defaults and
station sorting.
Signal source Select antenna/cable (analogue), DVB-T, DVB-C or DVB-S
here depending on which signal source you want to search
for new stations.
A configuration of DVB-T and DVB-S
called by the green button (see also page 23 and 24).
➠ Calling up the DVB antenna configuration causes the
Change search settings dialogue to be quit. You must
call up the dialogue again after finishing the configu-
ration.
Antenna/cable: With selection of set location the conventional TV
TV/colour standard/colour standard is the default. This should only
standard be changed if stations with other standards are to be
searched.
Encrypted You can state whether coded stations are to be searched
stations for in the search/update.
are also searched for. However, these stations can only
be received in connection with a CA module and the ap-
propriate Smart Card.
you need to receive certain stations. Handling of the CA
module is described on page 57.
DVB-T If you want to run the station search independently of
Search method the channel grid, select frequency search for the search
method.
DVB-C
With the selection of set location the conventional set-
Settings tings will be preset. Only change this if you know other
symbol rates and modulation types or if you have to
specify the network ID for your cable network (informa-
tion available from your cable network provider).
If you want to run the station search independently of
the channel grid, select frequency search for the search
method.
DVB-S If you want to run the station search independently of
Settings the channel grid, select frequency search for the search
method.
The symbol rate is specified by the satellite provider and
normally does not need to be adjusted.
(1 Equipment and upgrade options, see page 131.
antennas can also be
(1
Select yes then coded stations
Ask your dealer which Smart Card
(1