Table of Contents
Advertisement
To reset the seat to its normal stopping position:
1. After encountering the new stopping position, press the power seat
control again to override.
2. Continue pressing the control until it reaches the end of the seat
track.
3. Continue pressing the control for about two seconds. You will feel the
seat bounce back slightly.
Multi-Contour Active Motion™ Seat (If Equipped)
Note: The massage system will turn off after 20 minutes.
Note: The engine must be running or the vehicle must be in accessory
mode to activate the seats.
Note: Allow a few seconds for any selection to activate. The seat back
and cushion massage cannot function at the same time.
A
• Seat cushion massage: Press and release the front portion of the
massage control (A). Press again to cancel or press the lumbar control
to cancel.
• Seat back massage: Press and release the rear portion of the massage
button (A). Press again to cancel or press the lumbar control to
cancel.
• Lumbar selection: Press either up or down on the lumbar control (B)
to select the top, middle, or bottom part of the seat back.
2014 MKS (mks)
Owners Guide gf, 2nd Printing, December 2013
USA (fus)
Seats
Power Lumbar
A. Press the top of the control to raise the height
of the lumbar support. Press the bottom of the
control to lower the height of the lumbar support
B. Press the front of the control to adjust
firmness. Press the rear of the control to adjust
softness.
A. Cushion and seat back massage
B
control
B. Lumbar control
C. Power seat controls
C
135
Advertisement
Table of Contents
