Table of Contents
Advertisement
Product Information
Specifications
The following table lists the specifications for the AXB-232++.
Specifications
Power
Processor
Asynchronous data
standards
Buffers
Front Panel
AXlink LEDs
RX LED (Red)
TX LED (Red)
DEVICE DIP Switch
RS232/422 DIP Switch
Rear Panel
Hardware handshaking
connector
RS422/232 connector
AXlink connector
Internal Jumpers
Supports
Dimensions (HWD)
Weight
Enclosure
Included Accessories
Optional Accessories
2
12 VDC @ 160 mA
On board 32-bit processor and 384K (of non-volatile memory) run Axcess
programs independent of the control system. This relieves the AXlink bus and
controller for the processing time for controlling those devices. (Requires Axcess
Version 3.0 or higher.)
• Baud rates - 300, 600, 1200. 2400, 4800, 9600, 19200 and 38400.
56400 is supported via the BAUDMED Send Command (see the
Send_Commands section on page 9 for details).
115200 is supported via the BAUDHIGH Send Command (see the
Send_Commands section on page 9 for details).
• Data bits - 7, 8, and 9
• Stop bits - 1 and 2
• Parity - None, Odd, Even, Mark and Space
• 1KB input buffer
• 1KB AXlink buffer
Green AXlink status indicator:
• Full-Off indicates no power is being received or the controller is not functioning
properly.
• One blink per second power is active and AXlink communication is functioning.
• Full-On indicates power is active and AXlink data communication is not
functional.
Blinks to indicate the AXB-232++ is receiving RS-232, RS-422, or RS-485 data.
The RX LED blinks even if the data being received is incorrect.
Blinks to indicate the AXB-232++ is sending RS-232, RS-422, or RS-485 data.
An eight-position DIP switch used to set the device number for the AXB-232++.
Refer to Setting the DEVICE DIP switch, on page 4, and Setting jumper JP5 to set
the RS-422 port for RS-485 use section on page 4 for more information.
An eight-position DIP switch used to set the communication parameters for the
RS-232/422 device. Refer to Setting the RS-232/422 DIP switch, on page 5, for
more information.
An RTS/CTS data connector that can be wired for hardware handshaking if called
for by the controlled device (4-pin male).
A captive-wire connector wired for RS-422/232 data control (8-pin male).
Receives power and data via the AXlink bus and AXlink system controller
(4-pin male).
Sets differential input termination and enables RS-485 output.
XON/XOFF software and hardware handshaking
1.5" x 5.5" x 5.5" (3.81 cm x 13.97 cm x 13.97 cm)
1.1 lbs. (498.95 g)
Metal with black matte finish
• AXlink connector (4-pin female)
• Phoenix connector (8-pin male)
• CC-232 Control Cable
• AC-RK Accessory Rack Kit
• 12 VDC power supply, 800 mA
AXB-232++ RS-232/422/485 Interface
Advertisement
Table of Contents
