Troy-Bilt Pony Operator's Manual page 9

Reverse Clutch Control
1. Carefully unwrap the reverse clutch control cable from its
shipping position and route it up along the inside edge of
the left side handlebar. See Fig. 3-5. A knob and large hex
nut is installed on the cable.
Left Side
Handlebar
Hex
Nut
Reverse Clutch
Control Cable
Figure 3-5
2. Insert the cable into the slot in the control panel and fit the
threaded assembly into the hole in the slot. Be sure that the
flat side of the threaded assembly is aligned with the flat
side of the hole. Slide the hex nut up the cable and tighten
it securely.
3. Test the function of the reverse clutch control cable by
pulling the knob out and releasing it. The knob should
return to its neutral position against the tapered bushing.
If it doesn't, contact your local authorized dealer or the
TROYBILT Technical Service Department for technical
assistance.
Reverse
Clutch
Control
Slot in
Knob
Control
Panel
Forward Clutch Cable
1. Remove any fasteners (rubber bands, tape, etc.) that may
secure the Forward Clutch Control levers to the handlebar.
See Fig. 3-6.
Forward Clutch
Control Levers
Figure 3-6
2. The forward clutch control cable (with attached spring) is
hanging loosely near the right-side wheel. Being careful
not to kink or stretch the cable, insert the z-connector into
the hole at the end of the forward clutch control linkage.
See Fig. 3-7.
Z-Connector
Forward Clutch
Control Spring
Figure 3-7
s
ectiOn
3 — a & s -u
sseMbly et p
9