Troubleshooting - Troy-Bilt Pony Operator's Manual

Troubleshooting

Problem
Engine does not start
Engine runs poorly or
overheats
Engine does not shut off
Wheels and Tines will not
turn
Tines turn, but wheels don't
Wheels Turn, but Tines
Don't
Poor tilling performance
Cause
1. Spark plug wire disconnected.
2. Engine Throttle Control Lever incorrectly set.
3. Fuel tank empty.
4. Stale gasoline.
5. Dirty air filter(s).
6. Defective or incorrectly gapped spark plug.
7. Carburetor out of adjustment.
8. Misadjusted throttle control.
9. Dirt or water in fuel tank.
1. Defective or incorrectly gapped spark plug.
2. Dirty air filter(s).
3. Carburetor out of adjustment.
4. Stale gasoline.
5. Dirt or water in fuel tank.
6. Engine cooling system clogged.
7. Oil level is low.
1. Misadjusted throttle control cable
1. Improper use of controls.
2. Misadjusted forward clutch control cable.
3. Misadjusted reverse clutch control cable.
4. Worn or broken clutch belt.
5. Internal transmission wear or damage.
6. Bolt and key loose in transmission pulley.
1. Wheel mounting hardware missing.
2. Bolt and key loose in transmission pulley.
3. Internal transmission wear or damage.
4. Misadjusted wheel gear cable.
5. Wheel Gear Lever not fully engaged.
1. Tine holder mounting hardware missing.
2. Internal transmission wear or damage.
1. Worn tines.
2. Improper Depth Regulator setting.
3. Incorrect throttle setting.
4. Belt(s) slipping.
Remedy
1. Reconnect wire.
2. Put lever in FAST position.
3. Add fuel.
4. Drain fuel and add fresh fuel.
5. Clean or replace filter(s).
6. Inspect spark plug.
7. See Engine Service Dealer.
8. See Engine Service Dealer.
9. See Engine Service Dealer.
1. Inspect spark plug (see Engine Manual).
2. Clean or replace (see Engine Manual).
3. See Engine Service Dealer.
4. Replace with fresh gasoline.
5. See Engine Service Dealer.
6. Clean air cooling system (see Engine Manual).
7. Check oil level (see Engine Manual).
1. See Engine Manual or Engine Service Dealer.
1. Review Controls & Features Section.
2. Adjust cable tension
3. Adjust cable tension
4. Check belts. Replace parts as needed.
5. Contact authorized service dealer.
6. Tighten bolt; check that key is in place.
1. Replace hardware.
2. Tighten bolt; check that key is in place.
3. Contact authorized service dealer.
4. See Maintenance & Adjustments Section
5. Engage lever.
1. Replace hardware.
2. Contact authorized serviced dealer.
1. See Service Section.
2. See Tilling Tips & Techniques.
3. See Controls & Features Section.
4. See Checking Clutch Belt Tension.
8
27