Table of Contents
Advertisement
92
Easy Entry and Exit Feature
When you switch the ignition off, the steering column will move to the
full up and forward position to allow extra room to exit your vehicle. The
column will return to the previous setting when you switch the ignition
on. You can enable or disable this feature in the information display.
See General Information in the Information Displays chapter.
Memory Feature
You can save and recall the steering column position with the memory
function. Refer to the Seats chapter.
Pressing the adjustment control during memory recall cancels the
operation. The column responds to the adjustment control.
The steering column sets a stopping position just short of the end of the
column position to prevent damage to the steering column. A new
stopping position sets if the steering column encounters an object when
tilting or telescoping.
To reset the steering column to its normal stopping position:
1. Press the steering column control again after encountering the new
stopping position.
2. Continue pressing the control until it reaches the end of the column
position.
A new stopping position is set. The next time you tilt or telescope the
steering column, it will stop just short of the end of the column position.
2014 Flex (471)
Owners Guide gf, 2nd Printing, November 2013
USA (fus)
Steering Wheel
Use the control on the side of the
steering column to adjust the
position.
To adjust:
• tilt: press the top or bottom of the
control
• telescope: press the front or rear
of the control.
Advertisement
Table of Contents
