Table of Contents
Advertisement
To Change The Spacer:
1.
The Floor Nailer is equipped with a factory pre-installed 25/32" Spacer (32) and
an additional uninstalled 1/2" Spacer (58). To change the Spacer:
A. Disconnect the Floor Nailer from its air supply.
B. Empty the Moveable Magazine (35) completely.
C. Attempt to fire the Floor Nailer into a piece of scrap wood to ensure that it is
disconnected and is incapable of firing any nails/staples.
D. Set the tool on its side to expose the three Screws (33).
E. Remove the three Screws (33). Then, remove the 25/32" Spacer (32).
F. Align the three mounting holes in the 1/2" Spacer (58) with the three
threaded mounting holes from which the Screws (33) were removed.
G. Secure the 1/2" Spacer (58) to the tool, using the three Screws (33).
Anytime any maintenance or repairs are done (including clearing jams), FIRST:
1.
Disconnect the Floor Nailer from its air supply.
2.
Empty the Moveable Magazine (35) completely, and leave it open.
3.
Attempt to fire the Floor Nailer into a piece of scrap wood to ensure that it is
disconnected and is incapable of firing any nails/staples.
Use eye and ear protection when clearing jams. Always wear ANSI
approved impact safety goggles and appropriate hearing protection.
1.
Occasionally, a cleat nail/staple may become jammed in the firing mechanism of
the Floor Nailer, making the tool inoperable.
2.
To remove a jammed cleat nail/staple, disconnect the tool from its air supply, lift
the Lock (44) and slide the Moveable Magazine (35) back until it locks in place.
Then, lean the Floor Nailer back.
3.
Remove all cleat nails/staples from the Moveable Magazine (35). Then press the
Lock (44) and slide the Moveable Magazine forward all the way, making sure it
locks in place.
SKU 97586
For technical questions, please call 1-800-444-3353
95658
SCREW (33)
SCREW (33)
SCREW (33)
SPACER (32 or 58)
CLEARING JAMS
PAGE 9
Hide quick links:
Advertisement
Table of Contents
