Troubleshooting - Bissell PROheat All-Rounder User Manual

T
roubleshooting
Reduce Spray or No Spray
Possible Cause
1. Make sure power is on
2. Solution tank may be empty
3. Tank may not be seated properly
4. Hose solution line may be disconnected
5. Wet clean is not turned on
Machine is not suctioning
Possible Cause
1. Collection tank may not be placed properly
2. Collection tank may not be
assembled properly
3.
Wand tool connections are not tight
4.
Collection tank is full
5.
Float has tripped
6.
Pre-motor filter is dirty
Built-in heater light does not illuminate
Possible Cause
1. The heater button has not been depressed
2. The ON/OFF button has not been depressed
Other maintenance or service not included in the manual should be performed by an
Thank you for selecting a BISSELL product.
16
w w w . b i s s e l l . c o m
Remedies
1. Press power button if needed
2. Fill tank according to directions
3. Turn ON/OFF, heater and wet clean
4. Check connection at front of
5. Depress wet clean button to turn on
Remedies
1. Open Quick Release™ Hose Door, lift
2. Check to make sure the top lid is
3.
4.
5.
6.
Remedies
1. Depress the heater button
2. Depress the ON/OFF button
authorized service representative.
WARNING:
To reduce the risk of fire,
electric shock or injury
unplug from outlet before
servicing.
button off. Remove and reseat tank
machine
out tank and re-seat. Re-latch Quick
Release™ Hose Door
properly seated
Check all connections
(At grip, wand and tool)
Push tight if necessary
Empty collection tank by following
instruction on page 9
Check to see if tank needs to be
emptied. Make sure float is down
towards bottom of tank
Remove top lid. Remove and
clean pre-motor filter by following
instructions on page 15
Filter must be completely dry
before using again