Wet Carpet Cleaning - Bissell PROheat All-Rounder User Manual

O
peration

Wet carpet cleaning

1. Attach carpet deep cleaning tool to end of wand.
2. Place carpet deep cleaning tool directly on
carpet. Pull the spray trigger to spray cleaning
solution while pulling the wand towards you.
3. Keeping nozzle of the carpet deep cleaning tool
firmly against the carpet surface, continue to
make slow forward and backward wet passes
until no more dirt can be removed.
Do not overwet.
4. Release spray trigger and make slow forward
and backward passes over the same area to
remove any residual dirty water.
5. Repeat wet cleaning passes until water
being pulled up appears clean.
6. Continue passes without pressing the spray
trigger until you can't see any more water
being pulled up.
7. Continue to clean entire carpet working in
1 m by 1 m sections.
8. If machine loses suction, stop spraying and
check the collection tank level. Empty if
necessary.
9. If the machine stops spraying turn off
wet clean button immediately and check the
solution tank level.
NOTE: Never run in wet clean mode when
the clean water formula tank is dry or
missing.
w w w . b i s s e l l . c o m
ATTENTION:
Some Berber carpets have a
tendency to fuzz with wear.
Repeated strokes in the same
area with an ordinary vacuum
or deep cleaner may aggravate
this condition.
11