Spot Cleaning Carpet & Upholstery - Bissell 2842 Series Manual

Spot Cleaning Carpet & Upholstery
For additional tips and tricks on using your machine visit BISSELL.ca/support.
Power
1. 2.
Flip the Formula Tank Cap Turn machine ON by
up to open. Add formula to the pressing the Power Button.
formula dot. No need to add
Note: The rotating brush
water! Click the Formula Tank
automatically turns on when
Cap into place and make sure
powering machine ON. Press
it's secure.
the Brush Button to turn off.
Suction
Channel
4. 5.
Scrub the area with the For maximum suction, tilt
Rotating PowerBrush, keeping the machine forward and firmly
the nose of the machine flat on press the Suction Channel
the ground, as shown. down on the cleaning surface.
Note: The Pet Tool's rubber bristles make cleaning and removing pet hair easy.
See page 7 for steps on switching the tool.
WARNING
Keep spray away from face. Failure to do so may result in personal injury.
IMPORTANT: Check the manufacturer's tag before cleaning upholstery. "W" or "WS" on the tag means you can use your Pet Stain
Eraser™. If tag is coded with an "S" (with diagonal strike-through), or says "Dry Clean Only," do not proceed. If manufacturer's tag
is missing or not coded, check with your furniture dealer.
Spray Spray
Brush
3.
To remove the spot or stain,
first tilt the machine down so
the Spray Tip is pointing at the
area. Press the Spray Button to
dispense formula.
6. Make sure to check the Dirty
Water Tank for when it reaches
the "MAX FULL" line. See next
page on how to empty.
BISSELL.ca 5