Table of Contents
Advertisement
C-1 Filling Formula & Water Tank
1. Remove tank by lifting it straight up, then
away from Lower Body.
2. Unscrew black cap located on bottom of
tank.
3. Fill with hand hot (not boiling) tap water
(140°F/60°C MAX) to WATER line. Fill rest of
tank with BISSELL 2X Formula to FORMULA
line. Replace and tighten black cap.
Caution: Do not microwave or boil water
before filling.
4. Place tank on Lower Body.
C-2 Carpet cleaning
1. Plug into proper outlet.
2. Adjust Retractable Handle by turning
counter-clockwise and lifting handle up.
Turn clockwise to secure.
3. With foot, press red Power Pedal,
located on back of machine.
NOTE: Handle must be in the full upright
position before cleaning.
4. With foot, press grey Recline Pedal
located next to Power Pedal.
5. While pressing trigger, make one slow
forward wet pass and another one back.
Caution: Do not overwet.
6. Release trigger and make one slow
forward and backward pass over the same
area.
7. Repeat steps 5 and 6 until solution being
pulled up appears clean.
8. Empty Dirty Water Tank when dirty water
reaches FULL line, or when Formula and
Water Tank is empty.
C-3 Area rug cleaning
Important! Please check manufacturer's tag
before cleaning area rugs for any specialized
cleaning instructions. We do not recommend
deep cleaning delicate, silk, wool, antique, or
area rugs without a manufacturer's tag.
When cleaning area rugs, place rug on a
sealed surface and test a small, inconspicuous
area for colorfastness. Your carpet cleaner
should not be used on unsealed surfaces.
Follow carpet cleaning instruction in section
C-2. Keep foot of cleaner perpendicular to
rug's edge with each cleaning pass to prevent
damage.
C-4 Empty the Dirty Water Tank
1. With foot, press the red Power Pedal to
turn off and unplug Power Cable from outlet.
2. Remove Dirty Water Tank from base of unit.
a. Release Dirty Water Tank latches (on
each side) by pulling up from bottom of
latch and then out.
b. Carefully remove tank by lifting up on
the tank handle.
3. Carry Dirty Water Tank to a toilet or sink.
To empty, pour out contents using opening
at back of tank.
4. Rinse tank thoroughly and replace on unit.
5. Refill Formula & Water Tank and continue
cleaning.
C-5 Cleaning after use
1. Unplug Power Cable from outlet.
2. Remove and rinse Dirty Water Tank
thoroughly.
3. Remove tank vent & foam filter (located
on top of tank) and rinse.
4. Clean nozzle window by lifting latch and
removing nozzle from machine. Rinse under
running water.
5. When finished replace nozzle and secure
with latch.
NOTE: For best results, it is recommended
that the nozzle is cleaned after each use.
6. Remove lint and hair from red gasket in
base of unit. (Do not remove gasket.)
7. Replace Dirty Water Tank on base of
machine and secure with latches.
ATTENTION
Some Berber carpets have a tendency to fuzz with wear.
Repeated strokes in the same area with an ordinary vacuum
or deep cleaner may aggravate this condition.
www.BISSELL.eu
7
Advertisement
Table of Contents
