Table of Contents
Advertisement
High Speed Pan/Tilt System
4.3
Connecting the Power Supply
The base with power supply box is available in two (2) power supply voltages (24 VAC or
230 VAC). Before proceeding with the installation, check the identification label of the prod-
uct to verify that the device coincides with the power supply requirements.
When the base is opened, the power supply board appears as shown below. To connect the
power supply, make the connections as seen in Figure 4.7.
Fig. 4.7 Connecting the Power Supply
To wire the power cable (not supplied), use Table 4.2 to attach the appropriate colored wire
to the appropriate terminal.
Per local Installer
Per local Installer
Green/Yellow
Blue
Brown
Green/Yellow
Table 4.2 Terminal Connections
Bosch Security Systems
CAUTION!
!
When connecting the base, make sure the power supply is disconnected and
that the disconnecting switch is open.
Power Supply and Bi-polar Disconnecting Switch
Wire Color
24 VAC Terminal Connection
Neutral
Live/Active
Earth
Wire Color
230 VAC Terminal Connection
Neutral
Live/Active
Earth
Instruction Manual
Installing the High Speed Pan/Tilt | en
F01U.073.990 | Version 1.0 | 2007.07
15
Advertisement
Table of Contents
