A.2 Pelco Protocol Mode - Bosch VEZ Series Installation Manual

AutoDome Easy II
Setting FastAddress with a Pelco Keyboard
1.
2.
3.
4.
5.
6.
7.
8.
9.
A.2 Pelco Protocol Mode
The Pelco Mode features Auto Baud Detection that
automatically detects and adjusts the AutoDome Easy II
protocol and baud rate to match that of the controller. The
AutoDome Easy II responds to Pelco-D or Pelco-P protocol
commands.
NOTICE!
The AutoDome Easy II supports only the RS-485 protocol while
in Pelco mode. It does not transmit responses back to the
controller.
Bosch Security Systems, Inc.
Press and hold 95-PRESET for two seconds to open the
Pelco Setup menu.
Move the joystick to select the Command Lock menu.
Press the FOCUS or the IRIS button to turn Command
Lock to OFF.
Move to the FastAddress menu and press the FOCUS or
the IRIS button to open the menu.
Use the joystick to enter the unique identifier for the
AutoDome Easy II.
– Move the joystick up or down to select the number.
– Move the joystick right to move to the next number
position.
Move the joystick right to select Continue. Then, press the
FOCUS or the IRIS button.
Use the keyboard to enter the FastAddress number. Then,
press the Camera button.
Note: You must first clear an assigned FastAddress number
to use the number for a different AutoDome Easy II.
Move the joystick down then back up to set the
FastAddress number.
Press the FOCUS or the IRIS button to store the
FastAddress number.
The on-screen display menu confirms that the AutoDome
Easy II stored the FastAddress number.
Installation Manual
| en 127
F.01U.164.478 | 2.0 | 2010.02