Off Timer; Remote Control; Clock Settings - Panasonic Diga DMR-EZ28 Operating Instructions Manual

Setup Menus
Off Timer
Select how long the unit remains on when it is not being used.
Perform step 1 of "Accessing the Setup Menus" (-+ 46).
(a ..,
to select "Setup", then
~
)
E) ..,
to select
"Off
Timer", then
~
0",
to select "2 Hours", "6 Hours"
or "Off", then
~
o
While pressing and holding
~,
press and hold the numbered button
ITJ,
(2),
or
[ID
corresponding to
the code set in step 4 for about 5
seconds to set.
o
~
to start auto setting.
The following dialog appears when setting is complete.
~~0_~_OK~_to_co_m_p_le_te_._---=========J
Clock Settings
414120061215 AM
CST .. ... . On
Time Zone EST
/
o ..,. . .
to select "Set Code 1", "Set Code
2", or "Set Code 3" then
~
to set.
( Set Clock Automatically )
After selecting "Clock Settings" (-+ above, step 3).
o ..,. . .
to select "Set Clock
Automatically", then
~
Perform step 1 of "Accessing the Setup Menus" (-+ 46)
(a ..,
to select "Setup", then
~
)
E) ..,
to select "Clock Settings", then
.~
)
After selecting "Parental Rating" (-+ 47, step 3)
( To change the password
(£)
Tips
To clear the password
(-+ 70, To reset the ratings level settings)
@
Notes
• Recording may fail when a wrong password was entered for
scheduled recording settings.
• "V-chip" technology enables restricted shows to be locked
according to TV ratings.
• The V-chip system that is used in this set is capable of blocking "NR"
programs (non rated, not applicable and none) as per FCC Rules Section
15.120(e)(2). If the option of blocking "NR" programs is chosen "unexpected
and possibly confusing results may occur, and you may not receive
emergency bulletins or any of the following types of programming:"
- Emergency Bulletins (Such as EAS messages, weather warnings and others)
-Locally originated programming
• News· Political
- Public Service Announcements
• Religious· Sports· Weather
o
Enter a 4-digit password with the
\.. numbered buttons, then
~
o ..,. . .
to select "Change Password",
then~
o
Enter the new password with the
numbered buttons, then
~
- A screen appears confirming that you have
set a password. Press [OK].
Remote Control
Use this function to synchronize the codes for the
remote control and the main unit.
Perform step 1 of "Accessing the Setup Menus" (-+ 46).
(a ..,
to select "Setup", then
~
)
E) ..,
to select "Remote Control",
then~ If the time is correct, [...] to select "Yes", then [OK].
- If you select "No", auto setting starts again, then the above
screen reappears. Repeat this step until the correct time appears.
• If the clock is not correct, set the clock with "Adjust Time Zone"
(-+ 49) or "Set Clock Manually"(-+ 49).
RQT9046