D-Terminal Output Level Adjustment - Panasonic AG-HPX500 Service Manual

2-3-1. D-Terminal Output Level adjustment

1. Confirm that the camera recorder set to NTSC mode.
Ex). : REC FORMAT (RECORDING SETUP / Setting menu) → 1080/60i
SYSTEM FREQ (OTHER FUNCTIONS / Setting menu) → 59.94Hz
2. Connect the WFM to the COMPONENT Y OUT with 75ohm termination.
NOTE: Component video cable and PIN-BNC conversion plug are used.
3. Adjust Y level "A" by clicking the adjustment button on Video / Frequency Adj. screen so that it is within
specification.
NOTE: The pedestal level is a standard.
4. Connect the WFM to the COMPONENT Pb OUT with 75ohm termination.
NOTE: Component video cable and PIN-BNC conversion plug are used.
5. Adjust Pb level "A" by clicking the adjustment button on Video / Frequency Adj. screen so that it is within
specification.
6. Connect the WFM to the COMPONENT Pr OUT with 75ohm termination.
NOTE: Component video cable and PIN-BNC conversion plug are used.
7. Adjust Pr level "A" by clicking the adjustment button on Video / Frequency Adj. screen so that it is within
specification.
A = 700mV ± 14mV
A = 525mV ± 11mV
A = 525mV ± 11mV
A
A
A
ELE-7