Special Safety Informations - Meyra 2.445 Operating Manual

Special safety informations

▲
For safety reasons, the wheelchair
must be unloaded (without bag-
gage and without user) during its
loading into a car or when a split
ramp is used.
▲
Ensure that the wheelchair can roll
back for a short distance (neutral
zone) if forward motion on the
ramp is interrupted or when set-
ting in motion at the bottom of
the ramp.
▲
Cars and vans should be parked
on a level and fi rm surface with
the handbrake on to prevent them
from rolling away.
▲
Ensure that the ramp cannot slip at
the ground end or at the transport
vehicle end.
▲
Ramps should be positioned so as
to leave enough space for wheel-
chair steering correction without
one of the wheels protruding over
the edge of the ramp.
▲
Only use the wheelchair on dry,
clean and undamaged ramps or
lifting equipment.
▲
Pre-select the lowest maximum
speed.
▲
Only approved ramps or lifting
platforms may be used.
Attention:
!
The loading capacity per ramp or
lifting equipment must be for the
wheelchair:
– greater than 100 kg without
driver and
– greater than 250 kg with driver
(fi xed ramp)!
Only tested and approved ramps
or lifting platforms intended for
wheelchair loading may be used.
31