Buick Regal 2011 Owner's Manual page 43

the driver window switches when
the lockout feature is active.
To restore power to the rear
windows, press the button again.
The light on the button goes out.
If the light flashes, the feature may
not be working properly.
Rear Window Lockout without
Power Safety Locks
For vehicles without power safety
locks, the rear window lockout
button is on the driver door.
Press to disable the rear window
controls. The light on the button
comes on indicating the feature is in
use. The rear windows can still be
raised or lowered using the driver
window switches when the lockout
feature is active. To restore power to
the rear windows, press the button
again. The light on the button goes
out. If the light flashes, the feature
may not be working properly.
Programming the Power
Windows
If the battery on the vehicle has
been recharged, disconnected, or is
not working, you will need to
reprogram each front power window
for the express-up feature to work.
Before reprogramming, replace or
recharge the vehicle's battery.
Keys, Doors and Windows
To program each front window,
follow these steps:
1. With the ignition in ACC/
ACCESSORY or ON/RUN,
or when Retained Accessory
Power (RAP) is active.
2. Press and hold the power
window switch until the window
is fully open.
3. Pull the power window switch up
until the window is fully closed.
4. Continue holding the switch up
for approximately two seconds
after the window is completely
closed.
The window is now reprogrammed.
Repeat the process for the other
windows.
2-13