Troubleshooting; Protective Circuit - York PACER 3503 Instruction Manual

MONITOR POWER SUPPLY
The training computer does not require any battery since it is supplied with power via the
running treadmill.

PROTECTIVE CIRCUIT

To protect your safety, this treadmill is designed and equipped with run away protection.
If the admissible operating speed of the treadmill is exceeded or fallen below, the protective
circuit will shut off the treadmill to protect you and the equipment. The treadmill will flicker all
display values to alert the user to the condition. Reset the treadmill by turning the power switch
on/off to return the treadmill back to the normal operating mode.
TROUBLE SHOOTING
WHEN TO CALL FOR HELP
This treadmill is designed with user safety as the number one priority. In the event of an electrical
failure, the treadmill will shut off automatically to prevent user injury and to prevent damage to
expensive components such as the motor.
When you encounter unusual behaviour from the treadmill, simply turn the power switch off and on
to reset the treadmill.
This should clear incidental errors and prepare the treadmill for normal operation again.
If, after you have reset the treadmill by turning the power switch off and on again, the treadmill is
still not operational, then it is time to call the helpline.
NO SIGNAL ON THE CONSOLE LCD WINDOWS
If there is no signal on the monitor, even after you have switched the treadmill off and on again to
reset, check the communication cable between monitor and motor controller.
First, make sure the connections are good and that the cable is not pinched or damaged.
If defective, ask your dealer for a replacement cable.
Error 1: Speed sensor error
Error 1 occurs when the console is not picking up the motor speed signal.
In other words, when the motor speed is not correctly fed back to the controller
console, the treadmill will shut off to protect the user and error 1 will be displayed
on the console.
When trouble shooting this error, do not stand on the running mat.
When you report error 1 to the service center, make sure you note down
the circumstantial details.
1. Is the motor operational? For example, if the motor is not working when you push
the start button, error 1 displays immediately.
Motor and running mat do not move.
2. If the treadmill was running, then it stopped and showed error 1,
then the motor is operational.
3. If the motor is operational, did the treadmill stop at low speeds
( 1.0 - 1.5 KPH ) or high speeds ( 10 KPH - 12 KPH )
* SHOULD YOU REQUIRE ANY ASSISTANCE REGARDING THIS PRODUCT PLEASE CONTACT YORK DIRECTLY.
and
*
PACER 3503 / 18