AMX Modero NXT-1200V Operation/Reference Manual page 71

FIG. 61 Wireless Settings page (Wireless Settings section)
You must first take the SSID name, Current Key string value, and panel MAC
Address information and then later enter it into the appropriate WAP dialog fields in
order to "sync-up" the secure connection. These values must be identically
reproduced on the target WAP.
7.
Touch the Network Name (SSID) field and from the Service Set Identifier keyboard, enter the SSID name
you will be using on your target Wireless Access Point (case sensitive).




8.
Leave the Authentication field reading Open System (default).


9.
Toggle the Encryption field (FIG. 61) until it reads WEP64 or WEP128. The 64/128 selection reflects the
bit-level of encryption security. This WEP encryption level must match the encryption level being used on
the WAP.
WEP will not work unless the same Default Key is set on both the panel and the
Wireless Access Point.
For example: if you have your Wireless Access Point set to default key 4 (which
was 01:02:03:04:05), you must set the panel's key 4 to 01:02:03:04:05.
10.
Toggle the Default Key field until the you've chosen a WEP Key value (from 1- 4) that matches what
you'll be using on your target WAP200G.

11.
With the proper WEP Key value displayed, press the Generate button to launch the WEP Passphrase
keyboard.
If you are wanting to have your target WAP (other than a 200G) generate the Current Key - Do not
press the Generate button and continue with Step 14.
NXD/T-1200V 12" Modero® Video Wall/Flush Mount Touch Panel
SSID field
Mini-PCI wireless card communication
settings (for use with a target WAP)
The card should be given the SSID used by the target WAP. If this field is left blank, the unit will
attempt to connect to the first available WAP. By default, all WAP200Gs use AMX as their assigned
SSID value.
One of the most common problems associated with connection to a WAP arise because the SSID
was not entered properly. You must maintain the same case when entering the SSID information.
ABC is not the same as Abc.
The alpha-numeric string is by default AMX but can later be changed to any 32-character entry.
This string must be duplicated within the Network Name (SSID) field on the WAP.
As an example, if you use TECHPUBS as your SSID, you must match this word and the case
within both the Network Name (SSID) field on the touch panel's Network Name SSID field and on
the WAP's Basic Wireless Configuration page.
Open System Authentication allows any device to join the network if the panel's SSID matches
the WAP's SSID. An Open System is recommended for communication between Modero panels
and an NXA-WAP200G.
Shared Key Authentication requires that the panel and the Wireless Access Point have the same
WEP Key to authenticate.
These WEP Key identifier values must match for both devices.
Configuring Communication
Changes on this page take
effect after using the BACK
button to return to the
previous page
59