AMX Modero NXT-1200V Operation/Reference Manual page 30

Touch Panel Accessories
NXA-PCI80211G
wireless card
I/O connector
Eight Housing
Screws
FIG. 21 Location of the Compact Flash card and I/O plate on NXT
2.
Insert the tip of a grounded flat-head screwdriver into one of the card removal grooves (located on either
side of the existing card), and gently pry the card out of the slot (FIG. 22). Repeat this process on the
opposite card removal groove. This alternating action causes the card to "wiggle" away from the on-board
connector pins.
Insert with arrow
facing towards the pins
FIG. 22 Removing/installing a Compact Flash Memory card
3.
Grip the old card by its sides and then carefully pull it out of the slot.
4.
Remove the new CF memory card from it's anti-static bag.
5.
Grip the sides of the new CF memory card and firmly insert it into the slot opening (with the arrow facing
towards the pins) until the contact pins are completely inside the flash card and it is then securely attached
to the pin sockets.
6.
To complete the upgrade process, close and resecure the panel enclosure using the procedures in the
following step.
18
plate
NXD/T-1200V 12" Modero® Video Wall/Flush Mount Touch Panel
Outer Housing
Card removal grooves
On-board Compact
Flash connector (with pins)
Connector opening
Compact Flash card