AMX Modero NXT-1200V Operation/Reference Manual page 62

Configuring Communication
If the panel is already powered, continue with steps 3.
The panel MUST be powered and configured for USB communication before
connecting the mini-USB connector to the panel's Program Port.
2.
Connect the terminal end of the 12 VDC-compliant power supply cable to the power connector on the
rear/side of the touch panel and then apply power.
3.
After the panel powers-up, press and hold the grey Front Setup Access button (for 3 seconds) to continue
with the setup process and proceed to the Setup page.
4.
Select Protected Setup > System Settings (located on the lower-left) to open the System Settings page
(FIG. 54).
FIG. 54 System Settings page - using a USB Connection Type
5.
Toggle the blue Type field (from the Master Connection section) until the choice cycles to USB. Refer to
the System Settings Page section on page 107 for more information about the fields on this page.
ALL fields are then greyed-out and read-only, but still display any previous network
information.
6.
Press the Back button on the touch panel to return to the Protected Setup page.
7.
Press the on-screen Reboot button to both save any changes and restart the panel. Remember that the
panel's connection type must be set to USB prior to rebooting the panel and prior to inserting the USB
connector.
8.
ONLY AFTER the unit displays the first panel page, THEN insert the mini-USB connector into the
Program Port on the panel. It may take a minute for the panel to detect the new connection and send a
signal to the PC (indicated by a green System Connection icon). If this is your first time installing the
USB driver, a USB driver installation popup window (FIG. 55) then appears on the screen.
50
No connection is established until
the Virtual Master becomes
active within Studio
Yellow Connection Status icon -
indicates an unreliable network
connection
Red Connection Status icon -
indicates no connection to a Master
Green Connection Status icon -
indicates communication to a Master
NXD/T-1200V 12" Modero® Video Wall/Flush Mount Touch Panel