4
Whenever possible, the vent hood should be
Step
secured to wall studs.
• With the template taped in place, use a
punch to mark all mounting screw locations.
Install
• Drill 1/8" pilot holes at the 6 punched
Mounting
locations.
Brackets
• Remove the template.
• Enlarge holes that did not enter studs to
3/8" and tap anchors for wall fasteners into
the holes.
– Drive screws into the fasteners to allow
• Secure the mounting brackets to the wall
studs with wood screws provided.
– For hollow walls, secure the mounting
5
Place the hood on the brackets and slide left to
right to align with rectangular slots at the top.
S tep
• Adjust the installation height by tightening
or loosening the screws "A" at the bottom
Install
of the brackets.
the Hood
• Align the hood lower mounting holes with
pilot holes in the wall.
• Using two large flat washers (supplied),
install wood screws or wall fastener screws,
loosely, into lower mounting holes. Do not
tighten.
• Level the hood by tightening or loosening
the screws "A" located on the bottom
mounting brackets.
• Tighten the lower mounting screws.
• Tighten screws "B" located at the top of the
mounting bracket against the hood to clamp
the position. Do not overtighten screws.
8
anchors to expand against the wall
material. Remove the screws for final
installation.
brackets through the anchors.
Installation
36" Vent Hood
Screws
Note: Screws "A" and "B" are pre-assembled onto the brackets.
Do not remove these screws.
To Secure Hood
Lower
Mounting Screws
"B"
Screws
"A"
Screws "B"
To Wall
Level and
Height
Adjustment
Screws "A"